-40%
Smoked Led Brake Tail Light Integrated Turn Signal For V-Rod
$ 39.57
- Description
- Size Guide
Description
Fits:l
Harley V-Rod
( Please Ensure This Part Fits For Your Motorcycle Before You Order.)
Description
:
It integrates the turn signal function, with built-in amber turn signal LED
70 ultra bright red LEDs for running/brake light
48 ultra bright amber LEDs for turn signals
DOT & E-Mark Certificated
Warranty 3 months
Accessories include resistors or relays and wire connectors
Note
:
This LED integrated tail light is direct replacement of stock tail light
You will need to splice the turn signal wires and attach to the taillight
Some Wiring needed, not plug and play, easy to install
Installation instructions not included, recommend installed by professional.
Payment
:
We accept payment via PAYPAL ONLY.
Shipping
:
Item will be shipped within 1-2 business days after payment has been received. Please note we do not ship orders on Saturdays, Sundays, and national holidays.
Return
:
1. If for some reason you're not satisfied with our service or product quality, you can return the products to us and we will refund your money after we get the package! (Shipping cost is NOT refundable and you should responsible for the return shipping)
2. We will replace any unit that is found to be manufacture defect under normal operating conditions within 3 months of purchase. (Buyer is responsible for return shipping to us and we will cover return shipping back to you.).
About Feedback
:
Please contact us before you leave us negative or neutral feedback , communication can solve 99.9% of problems, we care for every customer.
Frequently Questions
:
Installation of Built-in turn signals:
Connect the two YELLOW wires to the positive turn signal wires using provided red connectors or alternately use your existing factory connectors.
Use the red connectors:
Place one wire inside along one channel, place another wire inside along the other channel. Push down the metal pin as it will make a small cut on each wire bridging the connectors. if you are using the resistors, place one end of the resistor in the middle of either channel along with the one wire.
Ground wire is not needed unless you are using resistors to adjustment the blinking rate or instrument panel garbled. The ground wire is the same color wire used on both turn signals.
1. Connect one end of the resistor to the ground wire on your turn signal harness from your bike.
2. Connect the other end of the resistor to both the YELLOW wire from our taillight and the positive turn signal wire from your turn signal harness from your bike.
3. Repeat the same process for the other side.
Wiring Diagram applicable to most bikes:
Black Wire(Negative); Green Wire(Brake); Red Wire(Running)